View Single Post
Old Dec 30, 2012, 05:30 AM
Stuey is offline
Find More Posts by Stuey
Registered User
Joined Apr 2000
1,060 Posts
Wemo minifan no spinner a big loss?

Hi guys I have just finished mounting a minifan in my 64mm F-15. I ran it up briefly on 3s to check the direction before fixing it in. Now it is glued in with the ali spinner I have checked it again with a full power run up on 4s. At about 1/3 throttle there is a slight vibration but is smooth through the rest of the range. I noticed the spinner does not look true when spinning slowly, and there is slight run out on the fixing screw head. Will I lose out much by leaving it off? It was very hard to push onto the rotor and is fitted ok as far as I can see.
Stuey is offline Find More Posts by Stuey
Reply With Quote