Thread: Discussion Schapel Sa882
View Single Post
Old Dec 27, 2012, 09:43 AM
John Wright is offline
Find More Posts by John Wright
Registered User
United Kingdom, Harleston
Joined May 2004
476 Posts
Back to work after the Christmas break. I had to work out a way to make the inlets so they were reasonably sculptural and yet fairly easy to make. I had to increase the size of the inlets because of the higher mass flow in my engine. I will make the ears so they are part of the cover and will come off with it. This means I can get to the inside to trim out the opening in the skin. I marked the position with pins so I know where to cut out. The cover will be subject to some forces and I will not rely on the magnet system but have a pull out wire that holds it in place.

John
John Wright is offline Find More Posts by John Wright
Reply With Quote