View Single Post
Old Dec 25, 2012, 03:22 PM
MassiveOverkill is offline
Find More Posts by MassiveOverkill
MassiveOverkill's Avatar
United States, SD, Custer
Joined Feb 2011
6,372 Posts
The LEDs can be pulled out of their hole, the leads cut and new ones soldered on. You may have to remove the RX board to get some extra slack. I don't know about the resistance though, but I'm sure some LED gurus will chime in.
MassiveOverkill is offline Find More Posts by MassiveOverkill
Site Sponsor
Latest blog entry: MassiveRC ZMR PDB
Reply With Quote