Originally Posted by numnutchris
MENU - AUX-CHAN and check your flaps channel is assigned to 3-way switch.
REVERSE the CH if flaps move the wrong way.
With the switch at full up, setup your servo so the flaps are level or whatever you mean with "full up"
Flip the switch and check the deflection rates, you might have to move linkages in the horns/holes.
If you want more precise control, use eg. P-MIXes to achieve movements, but you have to provide your setup then. (With no info I assumed easiest setup with flaps controlled by two servos on an y-harness connected to a single channel)
Thanks Chris! Appreciate the info. I just didnt know where to start looking through the manual. Now that you said that its through AUX-CHAN, I know now where to go!