Thread: Build Log Hobby King "SIX" hexa
View Single Post
Old Dec 23, 2012, 04:19 PM
bill34207 is online now
Find More Posts by bill34207
Redneck Injuneer
bill34207's Avatar
Bradenton, Florida
Joined Aug 2007
6,974 Posts
I guess it's about time for an update in here. Yesterday I programmed all the esc's, set the throttle endpoints on them and determined the wiring to get the correct rotation.
Worked on the Pursuit mono some more and took a ride up to St Peterburg to meet Tom from hoverthings.com. Picked up a Naza with GPS and a power distribution board.
Went flying for a while this morning and after lunch went back to work on the hexa. Took the frame back apart and installed the distribution board. Then, found that the esc battery side wires were not long enough to reach it. I looked through my building supplies and the smallest wire I had was 14 gauge so drilled the holes out in the board to accept that size and soldered in jumper wires to reach the esc's. I think it's time to take a break for a while now.
bill34207 is online now Find More Posts by bill34207
RCG Plus Member
Latest blog entry: Freewing 90 mm Super Scale F-16
Reply With Quote