Thread: Discussion Crius MultiWii AIO boards
View Single Post
Old Dec 22, 2012, 10:46 AM
QUENAZ is offline
Find More Posts by QUENAZ
Registered User
Brazil, São Paulo, São José dos Campos
Joined Aug 2012
68 Posts
NICE, MAN!!!
Do it what you think it works well!

Good job!

Quote:
Originally Posted by floyd0815 View Post
SCOOORE!!! Works - THX a lot!!!
I tried before (without DTR--RTS connected) because I've read somewhere that the DTR is to reboot the board - but maybe my bad english...
"The major difference with this board is that it brings out the DTR pin as opposed to the RTS pin of the FTDI cable. The DTR pin allows an Arduino target to auto-reset when a new Sketch is downloaded."
https://www.sparkfun.com/products/8772
Also I had connected RX to TX and TX to RX - WRONG - but now it works!!! THX

REALLY last question: Should I load up sketches with my setup or ???
QUENAZ is offline Find More Posts by QUENAZ
Reply With Quote