Thread: Discussion Crius MultiWii AIO boards
View Single Post
Old Dec 22, 2012, 06:48 AM
floyd0815 is offline
Find More Posts by floyd0815
Registered User
Joined Dec 2012
7 Posts
Quote:
Originally Posted by QUENAZ View Post
DTR - Data Terminal Ready
RTS - Request to Send

It will not damage your board. You should try it!
Good luck!
SCOOORE!!! Works - THX a lot!!!
I tried before (without DTR--RTS connected) because I've read somewhere that the DTR is to reboot the board - but maybe my bad english...
"The major difference with this board is that it brings out the DTR pin as opposed to the RTS pin of the FTDI cable. The DTR pin allows an Arduino target to auto-reset when a new Sketch is downloaded."
https://www.sparkfun.com/products/8772
Also I had connected RX to TX and TX to RX - WRONG - but now it works!!! THX

REALLY last question: Should I load up sketches with my setup or ???
floyd0815 is offline Find More Posts by floyd0815
Reply With Quote