Thread: Discussion Crius MultiWii AIO boards
View Single Post
Old Dec 22, 2012, 05:37 AM
QUENAZ is offline
Find More Posts by QUENAZ
Registered User
Brazil, São Paulo, São José dos Campos
Joined Aug 2012
68 Posts
No, you can not use USBASP.

USBASP pins:
: VCC :: MISO ::
: MOSI :: SCK ::
: GND :: RST ::

FTDI pins:
:: DTR :: RX :: TX :: VCC :: CTS :: GND ::

If you know eletronics, you might connect USBASP in the ISP Slot - Crius Multiwii.

Quote:
Originally Posted by sandrodadon View Post
Hello !

I have a Crius MultiWii SE Board - but no FTDI.

But i have an USBASP from Hobbyking, can i use it to programm my Crius SE?
If yes:
In which order do i have to put the ISP Pins on the Board?
Where is +5V, GND, MOSI and so on?

Thank you very much
Sandro
QUENAZ is offline Find More Posts by QUENAZ
Last edited by QUENAZ; Dec 22, 2012 at 06:03 AM. Reason: ISP slot
Reply With Quote