Thread: Discussion Cyclops Storm OSD
View Single Post
Old Dec 20, 2012, 05:53 AM
mrracer98 is offline
Find More Posts by mrracer98
Registered User
Joined Mar 2012
176 Posts
Quote:
Originally Posted by Cathay Stray View Post
Sorry guys if this was asked before, I'm reading the thread from the beginning but still on page 32...
I power on the Storm (bench so far, probably will take it out tmrw), everything works more or less as should, but even with GPS getting fixed, the red LED on the board always keeps flashing.
In my implication, it should flash while looking for signal and then go into solid on mode but it doesn't.
So, is it normal that the LED on the board flashes all the way regardless GPS status?

Thank you.
- Mark -
red LED flashes all the time, that is normal regardless of GPS fix.
mrracer98 is offline Find More Posts by mrracer98
Reply With Quote