Thread: Discussion Cyclops Storm OSD
View Single Post
Old Dec 20, 2012, 01:49 AM
Cathay Stray is offline
Find More Posts by Cathay Stray
Flying Zayin
Cathay Stray's Avatar
China, Guangdong, Guangzhou
Joined May 2012
1,174 Posts
LED flashing mode

Sorry guys if this was asked before, I'm reading the thread from the beginning but still on page 32...
I power on the Storm (bench so far, probably will take it out tmrw), everything works more or less as should, but even with GPS getting fixed, the red LED on the board always keeps flashing.
In my implication, it should flash while looking for signal and then go into solid on mode but it doesn't.
So, is it normal that the LED on the board flashes all the way regardless GPS status?

Thank you.
- Mark -
Cathay Stray is offline Find More Posts by Cathay Stray
Last edited by Cathay Stray; Dec 20, 2012 at 01:55 AM.
Reply With Quote