View Single Post
Old Dec 17, 2012, 05:06 PM
acuralegendz is offline
Find More Posts by acuralegendz
What goes up...
acuralegendz's Avatar
United States, NJ, Cherry Hill
Joined Feb 2012
1,023 Posts
Finished!!(The build at least)

Now I need to get my bed level. There were a few hangups, the assembly videos that were made for the kit were a bit off as I had received some newer parts. After flipping some of the motor connectors and figuring out where the end stop connections were I'm now able to "home" all three axis. It will extrude but all i have is abs until the other 3 rolls arrive. I tried a test print but the abs just curls and never gets stuck to the bed. I'm sure this is because the bed is not level and my temps aren't dialed in yet. All in all I'm very satisfied with the kit. Now I just have to get it to print!!!
acuralegendz is offline Find More Posts by acuralegendz
RCG Plus Member