View Single Post
Old Dec 16, 2012, 05:40 PM
HeliHaven is offline
Find More Posts by HeliHaven
chicken nuggets
Joined Aug 2011
238 Posts
Well, I just had a go with a JR system (X-378 7 channel) and what a mess. Jittering all over the place. I can use Aux to turn the gyro on and off, but cannot damp out the jittering no matter what percentages are set in the TX. The jittering is worse when in the 'Off' mode. It lessens markedly when the gyro is in the 'On' mode.
The worst of it is when inputting left aileron with the gyro in the 'off' state - man the servo jumps around like a jack hammer!

Also tried it in a Turnigy 9X upgraded with Sky9X mainboard running FrSky DJT and a D8R-XP RX - jittering just the same.

Then tried it in an old 35meg Futaba T6EX - working fine with no jittering at all.
Tried all three gyros I have and all the same. Will look at it all again tomorrow.
HeliHaven is offline Find More Posts by HeliHaven
Reply With Quote