View Single Post
Old Dec 14, 2012, 07:00 AM
BriGuy82 is offline
Find More Posts by BriGuy82
SemperFi!
BriGuy82's Avatar
United States, TX, Texarkana
Joined May 2012
337 Posts
I had to install a 3k ohm resistor between my audio out and my vtx. Actually, I'm bypassing my audio in on my Eagle Treee OSD and running a "y" off the OSD out for audio with the resistor. So my cam and vtx are connected directly to each other with the resistor coming from the audio out.

Long story short, I wansnt getting audio from my OSD. Only when I jumped it to my cam and vtx. Sent the OSD in, got it back las wk. I'm now getting my live reports such as altitude and speed from the OSD. But I still wasnt getting audio from my cam!

The resistor did help! Still somewhat muffled, and not as crisp as if I would run cam to
Vtx, but acceptable variable. Im happy.. By the way, ET reccomended this resistor, and for you all to know, I did not see any difference between 3k and 10k. So I went with the smallest one.
BriGuy82 is offline Find More Posts by BriGuy82
Reply With Quote