Originally Posted by mcansea
I have been using the n616setup program by isoprop which is great.
I have the #16 camera with teh version 49 mov software..
There is a motion sensativity of hi or low which does not work..
anybody have an answer for this..
Well, first of all, you've got your threads confused
This is the #11 thread. The only utilities I wrote for the #11 were for the accurate time setting, but that was a very long time ago!
Now back to your #16. Motion sensitivity was only introduced after
v0.49, so you'll have to update your firmware to v0.53 if you need that functionality. As you have noticed, parameters that are not valid for the installed firmware version will always be disabled in the GUI.