View Single Post
Old Dec 13, 2012, 07:42 PM
600Bob is offline
Find More Posts by 600Bob
Registered User
United States, OR, Canby
Joined Aug 2011
2,768 Posts
Quote:
Originally Posted by Patchitagain View Post
I drilled a hole just large enough for the sat cable coming from the RX area to the top of the fuse. Then I carved out a shallow groove to an area near the tail on the spine and placed the sat cable in the groove. I dremeled a hole just large enough for the sat to fit and placed it inside the hole, then covered it with white tape. Can't see it, doesn't snag, and no interference. Works great! Took about 30 minutes...
Hmmm, that sounds like a good idea. How do you make a clean cut/groove for the Sat lead, just a knife or a special tool?
600Bob is offline Find More Posts by 600Bob
Reply With Quote