View Single Post
Old Dec 13, 2012, 07:14 PM
petebur is offline
Find More Posts by petebur
Registered User
Joined Feb 2007
3 Posts
Input sensitivity

Mark,
I have a question about input sensitivity.

When I am flying my plane with the gyro turned off my plane flies like it did before gyro installation, but when I turn on the gyro the plane flies as if I had turned down the rate on my Tx. My airplane is more responsive in low rate with the gyro turned off that in high rate when the gyro turned on.

Since the gyro seems to reduce the response of my Tx input. I think I should increase the input sensitivity on the “Professional 1” tab page. The x, y, and z sensitivity is currently at 1.10. What is the range of input sensitivity and what increment would you suggest I use to start increasing the sensitivity of Tx input ?

I will add here that on the ground the control surfaces appear to move the same distance with and without the gyro turned on.

Am I on the right trail?

Pete
petebur is offline Find More Posts by petebur
Reply With Quote