View Single Post
Old Dec 13, 2012, 08:55 AM
wbender is offline
Find More Posts by wbender
Bill
Central NY
Joined Apr 2010
12 Posts
Thanks for the interest and encouragement.

I've gotten a little further, have assembled the landing gear assembly, servo/firewall mount, and firewall. Unfortunately when I went to join the servo/firewall mount to the landing gear assembly I discovered that the tabs on FW2 are not centered and of course I have then wrong with relation to FW3 &FW4. Now trying to decide if I should trim the tabs on FW2 or if that would weaken the assembly too much.
wbender is offline Find More Posts by wbender
Reply With Quote