Thread: Discussion DIY Laser Cutter
View Single Post
Old Dec 12, 2012, 09:02 PM
mew09 is offline
Find More Posts by mew09
Dr. Wylam
Rochester, MN
Joined Jan 2005
23 Posts
You are referring to the fact that this is a gantry based system, i.e. the laser tube is mounted on the x-axis. The top of the line KERN Lasers are built on this design. Moreover, the proof is in the pudding. The design holds up, is simple to align, and maintains alignment over a larger area better. BTW. I suspect most on regroups.com are less worried about engraving performance.
mew09 is offline Find More Posts by mew09
Reply With Quote