Thread: Sold RepRap 3D Printer
View Single Post
Old Dec 12, 2012, 08:55 PM
terriwang is offline
Find More Posts by terriwang
Trader Rating: 31
Sushi Chef
terriwang's Avatar
United States, CA, Meadow Vista
Joined Jan 2009
384 Posts
Trader Rating: 31
Sold
RepRap 3D Printer

Bought everything for build a 3D Printer , but never finish the project. I only finish build frame part. never put Electrical on.

1. Reprap Prusa Mendel SAE ABS Parts.
2. New Sanguinololu Rev 1.3a with All steper.
3. RepRap Heatbed MK1
4. LM8UU Linear Bearings for RepRap Prusa 12 pcs.
5. Full set Makergear Hot End Packs with extra Nozzle. Come with two Hot End( one fully build). (.5 & .35)
6. Over 100 pages visual instructions.
7. Over 12LB ABS filament 3mm
8. Nema 17 high torque stepper motors (1.8 degrees)
9. New Crimping Tool.

Only Thing your need to finish this project is a Power supply. Computer power supply will work.

Info for hot end:
http://www.makergear.com/products/operators-pack

Official Wiki:
http://et.wikipedia.org/wiki/RepRap

Many another extras.


$560 shipped.
terriwang is offline Find More Posts by terriwang
Last edited by terriwang; Dec 13, 2012 at 01:08 PM.