Thread: Discussion XPS Announcement
View Single Post
Old Dec 11, 2012, 03:49 PM
JimDrew is online now
Find More Posts by JimDrew
Xtreme Power Systems
Lake Havasu, AZ
Joined Jun 2005
16,942 Posts
I will need some feed back from you guys on what I should build for a big expander. I like the nice little compact version that I showed in some pics, but I really would like to make it look more like a typical power expander, with a double-stacked PCB and stand offs and make it a bit like the 16 channel receiver I have shown where there are pins front, sides, and rear. The Nano will then become a satellite receiver, with only a single wire necessary. You can put the Nano at the top of your rudder (inside) and run a long servo extension to the power expander board. That eliminates having the Nano around any wires. At that point, you plug your servos in just like you would a regular power expander, and power it with the heavy input leads. Ah... I guess I just start a new thread about this!
JimDrew is online now Find More Posts by JimDrew
RCG Plus Member
Reply With Quote