View Single Post
Old Dec 11, 2012, 09:28 AM
miru is offline
Find More Posts by miru
Registered User
Vista, CA
Joined Feb 2008
1,416 Posts
Quote:
Originally Posted by SJW2511 View Post
Hi guys, me again.

Quick question as im going to be attempting a GPS add on, namel using the MediaTek MT3329 module.

Im a bit stuck about when it comes to configuring it, setting the baud rate etc. I have all the commands to use, but what do I run the commands in on the pc? also do i configure it when its plugged into the arduino, then them both plugged into usb on pc?
Assuming your GPS unit 'speaks' NMEA you don't need to configure it unless it's default baudrate is over 57600, in which case you should configure it for something lower.
Hook up your GPS to the mod and run SETUP mode, anything you type on the keyboard will be properly framed and sent to the GPS once you hit 'return'.
miru is offline Find More Posts by miru
Reply With Quote