View Single Post
Old Dec 10, 2012, 09:06 PM
pencon is offline
Find More Posts by pencon
Registered User
Joined Dec 2008
1,712 Posts
Completed wing with sheeted aileron. I found a new source for sheet aluminum .005 thick roll 12 inches by 3 feet so the sheeting has now become way easier and quicker .I also replaced any tape I had on the plane because you could see the foam beading through it after scotch briting the surface .The second pic I took on an angle with a light shining from the side so it looks a lot more pronounced and there are still a couple of pen lines to half scuff off .
pencon is offline Find More Posts by pencon
Last edited by pencon; Dec 10, 2012 at 09:14 PM.
Reply With Quote