View Single Post
Old Dec 10, 2012, 10:50 AM
scott page is offline
Find More Posts by scott page
|Taranis|>|All other Tx's|
scott page's Avatar
United States, WA, Richland
Joined May 2009
6,779 Posts
Quote:
Originally Posted by TheCure View Post
Ansering the two posts above:

No, I am not binding in v8 mode on Tx. The switch is in middle position within my transmitter. I also tried with another frsky dht-equipped transmitter and get the same effect.

No, I didnt use the F/S button since the manual says not to when using the jumper configuration when binding in D mode:

"D_Mode (Telemetry)
Connect Ch1 & Ch2 signal pins of V8FR-II by provided jumper and then
connect battery to V8FR-II directly (no need to hold the F/S button on V8FR-II) "

This is the receiver in question:
http://www.frsky-rc.com/ShowProducts.asp?id=124

At this point you seem to have your bases covered. But I've included a photo of the DHT to assure this is what you mean. (a picture is worth 1000 words). If you have these two switches off and do the jumper correctly and are not binding -- then I'd say you do have receiver problems.
scott page is offline Find More Posts by scott page
Reply With Quote