Thread: Discussion GMFC Foam cutting software
View Single Post
Old Dec 10, 2012, 10:31 AM
RCWorks is offline
Find More Posts by RCWorks
Registered User
RCWorks's Avatar
Joined Aug 2003
1,984 Posts
Quote:
Originally Posted by danfield View Post
For now it looks as if I will have 2 controller boxes... a GMFC with a GGCv2 and a 4 axis HobbyCNC proboard and 24volt power supply... and a Smoothstepper with a HobbyCNC proboard with a 36 volt supply.

That would probably be easier than unplugging and plugging in motors on one board and if the new Y& Z motors have a different rating changing amp draw setting as well on the HCNC board.
All 6 steppers are the same Daves 305 in/oz I will just be moving the X axis's over and switching out the Y and Z for the part that goes across the table when the X's are back at Zero.

I'll have limit and home switches on this on too... While it was not an issue on the old machine.

My X axis's are rack and pinion driven, the y's are 5 start 1/2 in acme scres at .5 inches per turn. The Y and Z of the routher... Y is rack and pinion and Z is another 5 start lead screw at a half inch per turn..
RCWorks is offline Find More Posts by RCWorks
RCG Plus Member
Latest blog entry: Improved X2 Mill Spindle Lock
Reply With Quote