View Single Post
Old Dec 10, 2012, 05:51 AM
Whizgig is offline
Find More Posts by Whizgig
Eugene
Whizgig's Avatar
Australia, VIC, Delacombe
Joined Oct 2006
918 Posts
Quote:
Originally Posted by Parkflying View Post
That's two questions

Skyartec has a programmer for the Sky X302v Rx, should you need to make setting changes to the Rx

About the replacement ESC units, we have found that all of the OEM Skyartec ESCs we have used to replace bad ESC units on the bench for customers have worked correctly out of the package. See this RC Groups Post I wrote on how to set the Throttle High and Low points using the Transmitter: Skyartec ESC Throttle Reset Post
There is also a ESC Program Card available that you can use to change the tune, start up mode etc

Regards

Max
www.parkrcmodels.com
www.skyartec-usa.com
Firstly sorry for the 2 questions instead of only the one.

I tried the throttle reset thing but the RX didn't even respond to the TX at all it just flashed 4 times and turned off and the motor played it's music.
I am beginning to think that either the TX isn't transmitting a signal or the RX isn't receiving as it should have responded to the TX with the throttle up.

Also If I have to reset the RX with the programer and the ESC with the program card where can I get them and what are the default settings ?
Whizgig is offline Find More Posts by Whizgig
Last edited by Whizgig; Dec 10, 2012 at 06:19 AM.
Reply With Quote