Thread: Discussion GMFC Foam cutting software
View Single Post
Old Dec 10, 2012, 01:08 AM
gm.cnc is offline
Find More Posts by gm.cnc
Registered User
gm.cnc's Avatar
France
Joined Feb 2006
288 Posts
Quote:
Originally Posted by RCWorks View Post

...

I just wanted to end up with a machine that could use the first PC I ran in to at any seller of PCs and get one that works for this out of the box(No installing of a 32 bit OS to make Mach 3 happy.)... My old cutter is being retired, it was in operation since 2001 and still runs Windows 98 SE and GM software version 2.19. I was there about the time Gilles was starting out. I go by the rulw of old techs... "If it works don't touch it, for if you do it will be up beyond all repair and need replacing!". So since this machine has gone through 2 controllers (Foam Lynx and still has a HobbyCNC foam board) about 4 bow power supplies and the old drawer slides have gotten loose I figured it was time to put in something more lasting, the basis for this machine is heavy duty router parts.

.....
GMFC with the GGC V2 runs fine on windows 64bits. But I don't think that there will be a 64 bit GMFC driver for the parallel port. I just don't have such machine and the parallel port is now outdated tech...

GIlles
gm.cnc is offline Find More Posts by gm.cnc
Reply With Quote