Thread: Discussion Dynam SR Trainer ARF
View Single Post
Old Dec 09, 2012, 11:05 PM
Eric Henderson is offline
Find More Posts by Eric Henderson
Registered User
Eric Henderson's Avatar
United States, NV, Las Vegas
Joined Dec 2005
1,688 Posts
Quote:
Originally Posted by rcflyinff View Post
Nice mod Eric. I also dislike the stock battery box on this plane. I'm a little worried about cutting away at the wing root though I'm guessing you added the CF rod prior to joining the wings? If so, very good idea. I wish I would have thought about that prior to building ours.
I suggest that you could put your battery a bit higher. If I was doing it again I would do that. I would make a foam channel in one piece, cut a section out to take it and then glue it in the fuselage. BTW - unless you are going to do outside loops the wing front "block" is not really stressed that much.

The CF rod has to be where I put it becasue of the dihedral. The rod connects to the U/C blocks. I had to notch the wing seat accordingly.

I have not flown the SR in any wind yet. I mention this, because that is why I wanted the oppoprtunity to move my new CG forward again, hence the length of the slot.

Regards,

Eric.
Eric Henderson is offline Find More Posts by Eric Henderson
Reply With Quote