Originally Posted by D.Yoder
So here is where I'm at on the controls after my first test hover. Heli wants to spin to the left more than before. I followed the right up but please see above post
Also to add to Chaps advice, when you center the rudder trim lever, you will need to adjust the proportional mix trimmer pot screw on the 3 in 1 unit. Make small adjustments, and turn the screw opposite of the way the helicopter is spinning. Just as you did with the trim lever, so small adjustment clockwise if the helicopter is rotating to the left. Also you need to disconnect the power, then power back up for the proportional adjustment to initiate.