View Single Post
Old Dec 09, 2012, 06:38 PM
topforce is offline
Find More Posts by topforce
Registered User
USA
Joined Feb 2002
1,255 Posts
Help!
kk2.0 recurring problem #1 esc pinout

I have been flying kk2.0 boards for a while now with great success. I have 1 board that I have had problems with. At first I thought it was a bad motor or esc when this board was built into a spider quad. Now, I think the #1 pinout mabey has a problem. The board is currently built into an HK 550 hex, using HK blue series 30A ESCs, and turnigy 2632 1000 kv motors. The programming is for hex + configuration. Seems #1 motor will spin up, but in trying to get off ground it slows down and eventually stops. When throttled back to zero and started up again, it starts fine, but in the tipping and sliding around of trying to lift off, it will again slow down and stop.

It did this before when on the quad but that was in a 4X configuration so #1 motor was offset front and right which made handling very adverse. Now motor #1 is straight front and its very sketchy.

I had read on the HK forums that it could be an esc non compatibility problem. In building this hex, I used 3x new ESCs and motors along with 3x used ESCs and motors from the previous quad build. The #1 position this time is a new set of esc and motor.

Anybody have similar problem and figured out how to overcome?
topforce is offline Find More Posts by topforce
Reply With Quote