Thread: Discussion New: Multiplex Acro Master
View Single Post
Old Dec 09, 2012, 01:25 PM
Justapoke is offline
Find More Posts by Justapoke
Arcee Moron
Justapoke's Avatar
The Netherlands
Joined Jun 2012
1,068 Posts
Hey all AM experts!

Yesterday I picked up a Acro master kit from my local hobby shop, and have a shopping list ready for needed parts. Any thoughts about my list?

I hope the motor has enough power? The weight is a bit less than the stock Himax C 3516-1130 (134gram) but I will reinforce the nose with some plywood that adds weight. My kit came with the Alu motor mount.

Anyway here is the list:


Motor: Turnigy Aerodrive SK3 - 3536-1200kv
Specs.
Turns: 14T
Voltage: 3~4S Lipoly
RPM/V: 1200kv
Internal resistance: 0.028 Ohm
Max Loading: 38A
Max Power: 560W
Shaft Dia: 5.0mm
Bolt holes: 25mm
Bolt thread: M3
Weight: 111g

Lipo: Have a few Zippy Compact 3S 2200 20c - maybe go for 4S 2200's

ESC: Turnigy Plush 40amp

Prop: 11x5,5 ?

Landing gear: Carbon Fiber Landing Gear 130mm

Wheels: Light Foam Wheel Diam: 60, Width: 10mm

Servo's: 2x Hitec HS-82MG (tail) + 2x HS-65HB

Tail: On my FunCup I used this Tail Wheel Assembly
But maybe it's to heavy so i'm looking at: This or This



Hope this will work, anybody that used this specific motor, and is a 4S lipo a good or bad idea?

.
Justapoke is offline Find More Posts by Justapoke
Reply With Quote