Originally Posted by DarkHeli
Im trying to connect telemetry and minimOSD. I understand the RX only needs to be connected from osd but do I have to splice the rx into the 3dr telemetry or can I use a different UART port for minimosd and the original for the telemetry?
I'm not very good with electronics, but i'm learning
. So bear over me if this is totaly wrong.
I was also thinking of doing that, but it seems like uart0 and uart2 are the same. But there is a AutoMUX uart0 there which i hope'd i could solder to split those uarts and use uart0 pins for the MinimOSD.
A drawing to a novice would help if this came out bad