View Single Post
Old Dec 09, 2012, 02:53 AM
TheCure is offline
Find More Posts by TheCure
Wats the worst that can happen
TheCure's Avatar
Canada, BC, Surrey
Joined Jan 2009
573 Posts
I''ve just bought another v8fr-ii to use with my dht diy telemetry module.
I've followed the instructions to bind the receiver with my telemetry-enabled module by inserting a jumper across the data pins of chan 1&2. I use a 6v battery to directly power the receiver.
Power on transmitter in bind mode, power on receiver. Receiver red light stays solid. Remove power, remove jumper, power trans, receiver. The receiver's red light flashes indicating no signal.
I think i have a faulty receiver.
Any thoughts??
TheCure is offline Find More Posts by TheCure
Reply With Quote