Thread: Discussion Crius MultiWii AIO boards
View Single Post
Old Dec 08, 2012, 09:00 PM
Flying By is offline
Find More Posts by Flying By
Registered User
Canada, MB
Joined Feb 2012
505 Posts
Quote:
Originally Posted by Flying By View Post
I found a bit of a work-around, although I really want a solution.

It seems that there is a problem when a rx channel is plugged into D6 (rudder/yaw on the board).

If I leave that 1 channel unplugged when the board powers up, and then plug it in everything works fine, even after cycling the power on and off as long as D6 is not connected on power up.

Anyone else experience this?

Any way to correct it? Can it be programmed to use a different connector (such as D12) for the yaw channel?
Problem Solved!

Well, it was my own doing...I had not plugged in the 2 AUX channels (didn't think it was necessary to start with) and now that I have plugged in all 6 channels, it seems to be working fine.
Flying By is offline Find More Posts by Flying By
Reply With Quote