View Single Post
Old Dec 08, 2012, 08:19 PM
templton89 is offline
Find More Posts by templton89
Registered User
templton89's Avatar
United States, NY, Kings County
Joined Nov 2011
418 Posts
Quote:
Originally Posted by 98 SNAKE EATER View Post
Are the wires the same thin gauge stuff they used on the purple morors?
they are thinner than on purple motors, however they seem to be different material. Purple ones had large lose wire sleeve, and it would always break. Also those wires were a pain in the rear to solder in case you broke it or wanted to extend it.
HP stuff has more flexible thinner wire, with a nicely fitted sleeve whch is made of much better silicone rubber

Quote:
Originally Posted by quad007 View Post
yes it looks a bit thin, but no thinner than turnigy NTM wires.
If I remember correctly NTM wires were fairly thick, short and not flexible at all. Also it might be just my experience, but NTMs felt heavy and too power hungry compared to other motors in same class.
templton89 is offline Find More Posts by templton89
Reply With Quote