Thread: Discussion Crius MultiWii AIO boards
View Single Post
Old Dec 08, 2012, 08:09 PM
Flying By is offline
Find More Posts by Flying By
Registered User
Canada, MB
Joined Feb 2012
505 Posts
Quote:
Originally Posted by Flying By View Post
Similar issue as above.

I have the multiwii SEv1 board And when I use the multiwii config software It works fine until I plugged in my rudder channel At which point I had to then upload the sketch again In order for it to work. Works fine at that point unless I unplug the power from the board At which point then I have to upload the sketch again. Can read and write to the board just fine. Controls work from tx but as soon as I remove power and power it up again I have to upload the sketch once more. Using multiwii v2.0

Anyone know what I can do to correct this?
One time the GUI gave me the message that the GUI and the Arduino versions didn't match.
Flying By is offline Find More Posts by Flying By
Reply With Quote