View Single Post
Old Dec 08, 2012, 07:45 PM
i812 is offline
Find More Posts by i812
Registered User
i812's Avatar
Joined Aug 2009
5,386 Posts
This may explain why it might be possible to strip a Servo Gear without crashing:

Quote:
Originally Posted by i812 View Post
At first, I had problems with the Servo Saver mod slipping during full stick Max to Min pitch pumps, then upon close examination noticed the problem was due to me programming the TX to use 100% Pitch Travel, which was causing the top 2 Links to mechanically bind with the Blade Grips, preventing full travel to 100%. The Servo Saver Mod was slipping during the binding, and therefore were functioning by not allowing the Servo Gear to strip. Once I decreased the TX's Pitch travel back down to the factory recommended 6x% (I forgot the exact % specified in the User Manual), the Servo Saver Mod stopped slipping unless I crashed.
i812 is offline Find More Posts by i812
Reply With Quote