Thread: Discussion Crius MultiWii AIO boards
View Single Post
Old Dec 08, 2012, 06:57 PM
Flying By is offline
Find More Posts by Flying By
Registered User
Canada, MB
Joined Feb 2012
505 Posts
Keep uploading sketch

Similar issue as above.

I have the multiwii SEv1 board And when I use the multiwii config software It works fine until I plugged in my rudder channel At which point I had to then upload the sketch again In order for it to work. Works fine at that point unless I unplug the power from the board At which point then I have to upload the sketch again. Can read and write to the board just fine. Controls work from tx but as soon as I remove power and power it up again I have to upload the sketch once more. Using multiwii v2.0

Anyone know what I can do to correct this?
Flying By is offline Find More Posts by Flying By
Reply With Quote