Thread: Discussion Techone Rule!
View Single Post
Old Dec 08, 2012, 03:37 PM
likidysplit is offline
Find More Posts by likidysplit
Registered User
Joined Jul 2008
42 Posts
Spent a couple hours this morning making a sorta 3D interpritation
of the plane . Still half to draw the canalizer and the airbrakes .
I will do that after dinner ! The original plane is made from 5mm foam except for a few bits
and its got the wing sitting on top of the horizontal fuse (kinda old school) and all the gear placement holes are already cut out for you ! " THAT I DONT LIKE " i want to put my gear where i want to put my gear PERIOD !!!!

The plane i cut will be from all 3mm depron and will be milled instead of being cut through and coverd I plan to cut it at 30" wingspan and expect the finished plane should weigh under 100 gram AU.........
likidysplit is offline Find More Posts by likidysplit
Reply With Quote