View Single Post
Old Dec 08, 2012, 03:01 PM
CrashAffinity is offline
Find More Posts by CrashAffinity
Crashaffinity on youtube
CrashAffinity's Avatar
Canada, AB, Calgary
Joined Nov 2012
2,964 Posts
Quote:
Originally Posted by Gordks View Post
I had some control surfaces that were starting to separate on my HK 2M Minimoa when it was brand new. I used canopy glue (J & Z Super RCZ56) on the separations. There has never been a problem with those surfaces since. The glue is as flexible as the foam or more so and it sticks to that foam as well as anything I have ever tried. It is a bit hard to see, but there is an highly reflective area along the obvious separation in this photo (zoom in). That is the glue. It could be used all along the length of the hinge I suppose. Keep it thin though or it might stiffen the hinge a bit. But not any more than reenforced packing tape I would bet. And it will stay clean forever instead of starting to look grubby as the packing tape, or even more so, hinge tape, often does. It's good stuff!
ah, thanks for the tip, i may just go this route instead
CrashAffinity is offline Find More Posts by CrashAffinity
Reply With Quote