Thread: Discussion Install Pitot tube
View Single Post
Old Dec 08, 2012, 12:49 PM
goryc is offline
Find More Posts by goryc
Registered User
Italy, Sicilia, Messina
Joined Apr 2011
331 Posts
Quote:
Originally Posted by goryc View Post
Thank you.
I installed the pipe and the Airspeed microsensor according to the specifications but I have a feeling that does not work well!
I tried to blow, from about 50cm, with a hair dryer cold air and he measured on the scale ladder 20 km / h (very oscillated) and when I turned off the hair dryer, the OSD has been the max bed. I knew that the maximum value is read on the microsensor but I do not think that should also appear on the screen! Or wrong?
There are problems with the various releases of the firmware? I use the 10.43.
Thank you.
Gory
I solved it!
I swapped the position of the two tubes. Now it works perfectly!
I have to just try it in real life. Unfortunately I have to wait a long time before taking flight in my model! The weather is very bad for the next 10-15 days!
Thank you
Gory
goryc is offline Find More Posts by goryc
Reply With Quote