View Single Post
Old Dec 08, 2012, 08:41 AM
Whiskey Whiskey is offline
Find More Posts by Whiskey Whiskey
Registered User
United States, CA, Fairfield
Joined Jul 2004
498 Posts
I rigged my elevators as the manual suggested: Outer servo arm, mid elevator control arm and 100% end point adjustment on the transmitter.

Still only 4 flights total, but I'm always over correcting on the takeoff after it leaps into the air. Even with the recommended low dual rate selected. (This why I haven't posted any videos, lol)

No crashes so far, I'd use that set up again though. Just keep in mind to not over correct too much on take off.
Whiskey Whiskey is offline Find More Posts by Whiskey Whiskey
Reply With Quote