Thread: Discussion GMFC Foam cutting software
View Single Post
Old Dec 07, 2012, 11:47 PM
RCWorks is offline
Find More Posts by RCWorks
Registered User
RCWorks's Avatar
Joined Aug 2003
1,984 Posts
Quote:
Originally Posted by danfield View Post
Thought I would post a pic of the "Kit", I know I like to see pics.

GGCv2 on the left of course.
1 ea Backlit in Blue Large character 16x1 LCD
3 ea Toggle Switches
3 ea Push Buttons
3 ea LED's, Red, Yellow and Blue
1 ea Double ended for 2 ea 14 Pin Flat Ribbon connector. 18" Lg, you cut to length you need.

Regards
Dan
Update: Also now included.
1 ea 2K resistor - Needed if the Text is too bright.

2 ea 180 ohm 1/4 watt res. for the Yellow and Red LED's
1 ea 100 ohm 1/4 watt res. for the Clear LED, that is actually Blue
Do you think the GGCv2 will work with Mach 3 and a HobbyCNC 4 Axis pro board? I don't relish the idea of building another machine and hobbling it with a 32 bit copy of Windows 7 that won't see over 4 gigs of ram just to run an LPTx port... Saves me putting up a second PC and controller since my table converts to a Mill...
RCWorks is offline Find More Posts by RCWorks
RCG Plus Member
Last edited by RCWorks; Dec 08, 2012 at 01:18 AM.
Reply With Quote