Thread: Discussion RhinoCam
View Single Post
Old Dec 07, 2012, 10:00 PM
tom43004 is offline
Find More Posts by tom43004
Father of Fr3aK, DLG Pilot
tom43004's Avatar
USA, OH, Worthington
Joined May 2002
7,368 Posts
Between two lines machining - available in RhinoCam Pro

Do an offset curve of your LE curve, then machine "between two curves" with a very small stopover. The paths will be parallel to the LE.
tom43004 is offline Find More Posts by tom43004
Reply With Quote