View Single Post
Old Dec 07, 2012, 06:42 PM
Clavin01 is offline
Find More Posts by Clavin01
Registered User
Clavin01's Avatar
USA, MD, Glen Burnie
Joined Sep 2008
139 Posts
Joe

1st Sorry about my Typo in previous post where I typed MP 4.7 Should have been 2.7 r4
When I click on terminal I get the correct info
See Pic, Typed Setup and then erase all OK
Then go to Flight Data, Click on Connect and get the Mavlink box
see next Pic, in 3rd Pic you will see up top right corner it says 100%
Lower right say Stablize, and No Gps I followed your instructions on Page 1 of this forum
I have a ublox Crius cn-06 Reset to 5 Hz and 38400 Baud rate.
However I get no reading at all and the artificial horizon does not move.
Now at start up of mission planner the is an update for Ardino Mega 2560.inf

But it will not load, gives me a timeout error, any suggestions.

By the way the 1st pic was after I did a reset as you suggested in last post.
Thanks Cliff
Clavin01 is offline Find More Posts by Clavin01
Last edited by Clavin01; Dec 07, 2012 at 07:01 PM.