Thread: Discussion Bolt pattern
View Single Post
Old Dec 07, 2012, 08:22 AM
chemnut842 is offline
Find More Posts by chemnut842
Registered User
United States, MD, North East
Joined Apr 2011
281 Posts
Discussion
Bolt pattern

Ok, I think this is a good forum to start but I can move the topic if I have to.


I have a 4X4 inch aluminum plate (1/8 inch thick) that needs 12 holes drilled in a very specific orientation. I know I should use CNC for this but...

Is there some piece of software that I can place dots with specific measurements and print it out. Then, tape the paper to my aluminum plate and smack each dot with a center punch?

Is there some better way of doing this that does not involve CNC?

Thanks,

- Joe
chemnut842 is offline Find More Posts by chemnut842
Reply With Quote