View Single Post
Old Dec 06, 2012, 11:32 PM
barnstorm100 is offline
Find More Posts by barnstorm100
Registered User
barnstorm100's Avatar
United States, CA, Rancho Cordova
Joined Jan 2011
3,894 Posts
Quote:
Originally Posted by 2Doggs View Post
Yes, it should - and if it's the John_NZ FBL software, there are later versions too. the current one is 1.22.

You need to select the right com port. If you go into device manager, with the USB - serial adaptor connected, you should see it listed, along with the com port number, when you click on Ports (COM & LPT) as in the png image below. In my case, the adaptor is on Com27, but yours will likely be on a different port.



Then when you try to connect your gyro to the software, make sure you set the Com port to match the number shown in device manager.

On my laptop, I was struggling to get it to connect, but it worked after a re-boot, so if in doubt, try a re-boot.

Good luck!
On this program it tells me which com port its plugged into. If I switch it to 3 from 4 it shows the change in device manager and on the FBL program. How do you have 27 ports? I tried all 7 on my computer and it won't connect.
barnstorm100 is offline Find More Posts by barnstorm100
Reply With Quote