View Single Post
Old Dec 06, 2012, 09:19 PM
Bob Hunt is offline
Find More Posts by Bob Hunt
Mustang Fever
Joined Jan 2005
434 Posts
Thanks, Dan.

The idea behind the hose clamp is to make it easier to get the fan out down the road, if it needs to be replaced or whatever. Getting tape out from the behind the blind side of the fan would be tough, and replacing it afterwards even tougher. I'm thinking, loosen the clamp, slide the exhaust tube to the rear an inch, and pull the fan.

Don't know why I went to all the hassle of making a template for the exhaust. I just now rolled the PETG up and slid it in there. All I gotta do is clamp it down, make some marks on it with a sharpie and proceed. Must have my head in rectal defilade, again.
Bob Hunt is offline Find More Posts by Bob Hunt
Reply With Quote