View Single Post
Old Dec 06, 2012, 08:21 PM
jabram is offline
Find More Posts by jabram
Registered User
Joined Jul 2012
4,767 Posts
Quote:
Originally Posted by view27 View Post
Hi Joe,
That is correct. I found that A8 is Throttle and A10 is Yaw in Mission Planner and I am running MP NG. I am expecting the ESC's next week sometime so it will be interesting to see if it arms.
Maybe they have changed something on the board as I did have to wait a couple of months for them to come off backorder.
OK on reversing the Pitch. I will check all the settings and calibrations properly when the ESC"s arrive. I have no doubt there will be another couple of questions to come although there are a lot of answers already on the forum.

Thanks Again
Bruce
Which Mega board do you have ?

Can you post a photo of your Mega board ?

Where did you buy it?

What you are saying, it is possible but it would have to be a different board..

Can you try something to completely rule out any error.

Using only one connection from the receiver, say the Throttle channel.

Disconnect all 4 wires from A8,A9,A10,A11

Connect the single throttle one at a time to each of A8, A9 A10, A11 and confirm in Mission Planner Radio Calibration which channel you see that throttle signal on.
jabram is offline Find More Posts by jabram
Last edited by jabram; Dec 06, 2012 at 08:28 PM.