Thread: New Product Eon F3P- testing
View Single Post
Old Dec 06, 2012, 07:31 PM
likidysplit is offline
Find More Posts by likidysplit
Registered User
Joined Jul 2008
42 Posts
Here is a screen shot of what the plans will look like.
But i do have a couple questions . Should i seperate the wings from the fuse for you ? It would make for less paper wasted if you only had to print half a wing .


also im confused as to the size and placement on the canalizers , are they
horizontal like the fuse or do they have a slight negative angle at the front ?


I did add some airbrakes just because !
likidysplit is offline Find More Posts by likidysplit
Reply With Quote