Thread: Question Need advice on g92 use
View Single Post
Old Dec 06, 2012, 05:52 PM
Roto Rob is online now
Find More Posts by Roto Rob
Registered User
Denver, CO
Joined Dec 2005
6,903 Posts
G92 is a command for the mill controller. Normally people will generate the g-code. Then in a text, or g-code editor copy the parts g-code, then insert the g92 between the parts. Here is an example. Easy to get lost, so good idea to run a simulation if you have the software to do that.
http://www.cncezpro.com/g92m.cfm

You probably can also do the cut, and paste in the Millmaster software. Then you would need to generate the tool path for each part in the Millmaster software. I don't use your software. In mine I would just use the same settings, and just select the different geometry. Or I can select all the geometry in one operation. It will move the tool to the clearance height, and move to the next geometry.
Roto Rob is online now Find More Posts by Roto Rob
Last edited by Roto Rob; Dec 06, 2012 at 06:01 PM.
Reply With Quote